Scroll Top

A Guide To Sharpening Hedge Trimmer Blades

Sharpening Hedge Trimmer Blades

Sharpening hedge trimmer blades is a simple yet daunting affair. In fact, a simple mistake while sharpening the blades could see your hedge trimmer lose its effectiveness.

This begs the questions; how do we do it like experts? How do we sharpen our hedge trimmers without altering its performance? If these are questions lingering in your mind, I got your back.

I have delved into the topic and prepared a simple blade sharpening guide. To make it clear, I will break it down into simple and precise steps.

Read Here- How to Test Hedge Trimmer Properly?

How To Sharpening Hedge Trimmer Blades?

Place Your Hedge Trimmer on a Stable Flat Surface

The first in sharpening hedge trimmer blades is placing it on a level surface. Failure to place your hedge trimmer on a level ground could result in slight differences in the amount of sharpening you do on different blades. For that reason, you need to ensure that the surface is flat.Sharpening Hedge Trimmer Blades

Wipe Away Dust and Debris

Dust and debris could affect the filing and sharpening process. This is where most people miss a step. And yes, failure to remove dust and debris result in an imperfect sharpening process. For that reason, you need to wipe all the dust so that you can achieve impressive results.

Check Out Top Rated Hedge Trimmers

Set a Mill File in The Groove of The Tooth You Want to Sharpen First

The next step is setting a mill file on the groove of the tooth you want to work on first. Since the mill file is quite crucial in the entire process, you need to push it down carefully so that it gets to the tooth point. This way, you can be sure to have perfect results.

File The Tooth for About 20 Times

Now, you can start sharpening hedge trimmer blades. Of utmost importance to note is; do not over-sharpen the teeth. This is because over-doing it weakens the blades. For that reason, 10 to 20 times are enough depending on the state of the teeth.

Check Out Tanaka TCH22ECP2 30-Inch Commercial Double-Sided Blades- Tanaka Hedge Trimmer Review

Now Re-position The Mill File to all Other Teeth Applying Similar Technique

After handling the first tooth, the same procedure is supposed to be applied to all the other teeth. You need to place the mill file on each groove and push it down so that it gets the tooth’s point.

After that, you can start the filing. It is important that you do the filing similar times for each tooth in order to attain uniformity.A Guide To Sharpening Hedge Trimmer Blades

Overturn The Trimmer and Wipe The Flat Parts of The Teeth With Sandpaper

After you are done with the teeth, you can now flip over the trimmer such that the teeth face upwards. Now, work on the flat parts of the teeth with a sand paper to make them sharp as well.

Read Our Update Review- Best Gas Hedge Trimmer Review

Wipe The Teeth with a Soft Cloth

You are now done sharpening hedge trimmer blades. Wipe it with a soft cloth to remove and powder form as a result of the entire filing process. You are now ready to go.

In a jiffy, although sharpening hedge trimmer blades is an easy task, one needs to follow these steps keenly. You should know Safety Tips for Hedge Trimmer

Leave a Reply

Your email address will not be published. Required fields are marked *

Pin It on Pinterest

Share This
Scroll Top
Scroll Top